Z.Vex

• Fuzz
• With the five controls for different levels and bias you can create your own personal fuzz sound
• Controller: Drive - Vol - Comp - Gate - Rod
• LED: Effect On
• Footswitch: Effect Bypass
• Connections: Input (6.3 mm jack) - Output (6.3 mm jack) - Power supply connector (coaxial connection 5.5 x 2.1 mm - negative pole inside)
• Operation with 9 V battery or 9 V DC power supply (not included, suitable power supply: Art.409939)
• True bypass
• Dimensions (W x D x H): 67 x 110 x 51 mm

• Classic '60s fuzz
• From tight, radical fuzz sounds that cut off as you stop playing, to intermodulation oscillations that fight for control of your tone as the sound subsides, through to radio sounds and octave-like fuzz
• Controls: Vol, Gate, Comp, Drive, Bar
• True bypass
• Power consumption: 40 mA
• Power supply using 9 V battery or 9 V power supply unit (not included, suitable PSU available under article nr 409939)
• Dimensions: (W x H x D) 119 x 46 x 60 mm
• Made in USA

• Volume, Tone, Fuzz
• 3-Way bass cutoff
• PW (pulse width)
• Relax / Push (input sensitivity)
• 9 Volt
• Power consumption: approx. 1 mA

Note: Power supply is not included

• Lo-Fi Chorus / Vibrato
• Mixes a brilliant & compressed clean signal with a dirty, modulated Lo-Fi signal for eerie chorus and pulsating vibrato sounds
• Controls: Volume, Tone, Comp / Lo-Fi, Depth, Speed
• Power consumption: 20 mA
• Power supply via 9 V battery or 9 V power supply unit (not included, suitable PSU available under article nr 409939)
• Dimensions (W x H x D): 119 x 46 x 60 mm
• Made in USA

• Fuzz
• Controls for: Volume and Waveform
• Internal switch to toggle between guitar and bass modes
• Very effective mids
• Power consumption: approx. 10 mA
• No battery operation possible
• 9V DC (center negative) Power supply is required (not included, suitable power supply available Art.409939)

Of course you can operate the pedal with any other amplifier as well, but to hear the sound Zachary Vex had in mind when he developed this pedal, you should try it with a Marshall amplifier at least once. The degree of distortion up to the clean sound, can be controlled very easily with the volume knob on the guitar.

The boost channel can be either operated alone or in conjunction with the "distortron engine". The boost channel is switched after the "distortron engine" to put extra power in to the amp again if both channels are turned on, increasing the volume for a better solo play.

• Simulates the "British setting" of an old Marshall amp
• Power supply optional available (409939)

• Distorters
• Simulates the classic Fender 59er Tweed Bassmann non-master-volume amplifier
• The sensitivity of the pedal makes it easy to adjust the degree of distortion using the guitar's potentiometer
• The boost channel is switched after the zero channel, and can be operated either alone or in conjunction with the zero channel
• Controls: Volume, tone, drive, boost, LED: Effect on
• Foot switch: Effect bypass - Boost off/ on
• Input (6.3 mm jack) - Output (6.3 mm jack) Input (6.3 mm jack) - Output (6.3 mm jack) - Power supply connection (coaxial socket 5.5 x 2.1 mm - negative pole inside)
• Power consumption: 10 mA
• Power supply via 9 V DC power supply unit - suitable power supply unit: Article number 409939 (not included)
• True bypass
• Dimensions (W x D x H): 70 x 110 x 55 mm
• Weight: 306 g
• Made in USA

Note: Battery operation is not supported

• Fuzz
• Equally suitable for guitar and bass
• Unlike standard fuzz pedals, the bass frequencies are retained
• Controls: Output, EQ, Pinch and Wool
• True bypass
• Power consumption: 0.5 mA
• Power supply with 9V battery or 9V DC power supply (coaxial connection - minus on the inside, not included, matching power supply available under Article Nr 409939)
• Dimensions (W x D x H): 120 x 46 x 60 mm
• Weight: 260 g

• Controls for: Volume, Gate, Comp, Drive and Stap
• SupSwitch with 3 modes
• Battery operation possible, 9V DC power supply is required - both are not included
• Matching power supply: Art.409939