EBS

• Channels: 1
• Power: 250 W RMS
• Impedance: 4 Ohm
• Equipped with: 2 x 10" Celestion speakers (switchable)
• Controls: Gain, compressor/ limiter, bass, middle, mid frequency, treble, bright, volume
• Switch: Character on/ off, filter active on/ off
• Input: 6.3 mm jack
• Allows the possibility to combine it with one additional 4 Ohm - or two additional 8 Ohm - speaker cabinets
• Weight: 15 kg

• Overdrive / Boost
• Billy Sheehan signature model
• Analog design with gain and separate boost foot-switch
• Controls: Drive, Tone, Level & Clean
• Compressor with mini-switch for High/Mid/Off
• Phase inverter with mini-switch for Normal/Inv.
• Boost On/Off Low Noise Relay Footswitch with status LED
• On/Off Low Noise Relay Foot switch with status LED
• Drive Loop (allows to loop in further effects)
• Clean Loop (allows to loop in further effects)
• Fine tuner for adjusting the compression threshold level (Mid-Mode)
• Trim control for setting the boost
• Power consumption: 35 mA
• Power supply via 9 V battery or 9 V DC power supply (suitable power supply Article Nr. 409939, not included)
• Dimensions (W x H x D): 83 x 115 x 48 mm
• Weight: 420 g

The Swedish company EBS has existed since 1988.They've been specialising primarily on the needs of bass players, and even the staff members are all representatives of the bassists fraternity, so it's not surprising that they're actually developing products that make bassists' hearts beat faster.

Especially as far as effects devices are concerned, bassist were indeed most often neglected. A big problem has always been the fact that most of the effects are frequency clutter, in the very area where the bass guitar can least get over it, namely in the low frequencies. Precisely there the EBS effects are really unproblematic and they also have otherwise really interesting features to offer.

The bass IQ promotes less the intelligence of the bassist than its presence in funny fill-ins or solos. It is an analogue envelope filter or, as the saying goes, a car wah. From classic funky sounds to something really crazy - everything is possible!

• Triple Envelope Filter (Wah)
• True bypass

• Channels: 1
• Power: 250 W RMS
• Impedance: 4 Ohm
• Equipped with: 2 x 10" Celestion speakers (switchable)
• Controls: Gain, compressor/ limiter, bass, middle, mid frequency, treble, bright, volume
• Switch: Character on/ off, filter active on/ off
• Input: 6.3 mm jack
• Allows the possibility to combine it with one additional 4 Ohm - or two additional 8 Ohm - speaker cabinets
• Weight: 15 kg

• Power: 500 W at 2 Ohm
• Analog preamplifier with 4-band EQ
• Class D power amplifier
• Integrated compressor / limiter
• Effect loop
• Balanced XLR output (switch for pre/post Eq and Ground Lift)
• Line out and headphone output
• Dimensions: 32.5 x 25 x 7.5 cm
• Weight: 3.1 kg

• Compressor
• 3 Switchable compression modes: Tubesim, Multiband and Normal
• Controls: Comp, Sens and Gain
• 3-Way mode selector switch
• True Bypass
• Current consumption: 45 mA
• Power supply via a 9V battery or 9-18 V DC power supply unit (not included in delivery, suitable power supply unit: Article Nr. 409939)
• Dimensions (W x D x H): 67 x 115 x 48 mm
• Weight: 315 g

• Fully analogue
• Controls: Master, Blend, Level, Mid, Tone, Drive, Comp, Bass, Treble and Gain
• Inputs: 1x 6.3 mm bass input, 6.3 mm drive input
• Outputs: FX- Loop (Send & Return, 6.3 mm jack, 2x XLR(Pre/ Post, Post Bal Out), Effect loop
• Two footswitches for drive and mute
• Power supply: 9 V DC, 450 mA
• Dimensions: 168 x 124 x 53 mm
• Weight: 660 g
• Colour: Black
• Includes power supply

Slight traces of use

• New 2020 version
• Preserves the deep bass
• A new Range-switch makes possible to move the optimized focus area of the tracking to either higher up or lower down the fretboard.
• By adding a seamless tone control you can go from a present, focused octave sound that cuts through the mix all the way to a sub-bass backdrop of lows that discreetly supports the note you play
• Control: Normal, Tone, Octave
• Switches: Range high / low
• LED: effect on
• Footswitch: bypass effect
• Input: 6.3 mm jack@Output: 6.3 mm jack
• Mains adapter connection: Coaxial connector 5.5 x 2.1 mm, negative polarity inside
• Current consumption: 40 mA
• Power supply via 9 V battery or 9 V DC power supply (suitable power supply Art.409939, not included)
• Dimensions (W x D x H): 66 x 114 x 48 mm
• Weight: 315 g

• Stanley Clark Signature model
• Controls: 2x Gain, Treble, Filter Mid, Mid Frequency Band, Bass, 1x Volume
• Switches: Source (1/4"/ XLR), Phase (Normal/Invert), Electret (Off/PWR), 2x Type (HP/Notch)
• Buttons: Gnd Lift, SPKR Sim, Parallel FX Loop
• Effect loop
• 2 Footswitches for A/B and mute
• Power supply: 9 V DC, 500 mA
• Dimensions: 168 x 124 x 53 mm
• Weight: 660 g
• Colour: White
• Includes power supply unit

Connections:

• 2 Inputs: 6.3 mm jack
• Mic input with 48 V phantom power: XLR
• Auxiliary input: 3.5 mm jack
• FX- Loop output (send & return): 6.3 mm jack
• 1 Output: 6.3 mm jack
• Tuner output: 6.3 mm jack
• Pre/ Post, Post Bal output: XLR
• Headphone output: 3.5 mm jack