Electronics for Basses

• For electric basses
• Tandem potentiometer with active 2-band EQ
• Treble and bass: +/- 12 dB
• 4 Center adjustable frequencies: 2100 Hz, 3500 Hz, 4500 Hz, 7000 Hz
• Suitable for active and passive pickups

• With 3-band EQ
• 5 Knobs for volume, treble, middle, bass, balance control

• Active / passive switch (at volume control push / pull)
• Balance control without volume reduction in the center position
• Treble control in active mode +/- 18 dB @ 18 KHz
• Bass control +/- 14 dB @ 40 Hz
• Battery voltage is 9 V / 18 V
• Due to the high-quality electronics there is no difference between active and passive operation when the tone controls are in the middle position
• Prewired with highly flexible cables

• Prewired onboard bass preamp for J-style basses
• With a metal control plate
• Active preamp for passive pickups
• 4-Knob Layout with controls for: Master Volume / Balance / Vintage Tone Control (P/P) / Treble and Bass (stacked)
• Push/Pull function on the VTC control for preamp bypass
• Can be installed with either the included control plate or with an electronics panel
• Frequency esponse: 5 - 50,000 Hz
• Bass control offers +18 dB boost at 40 Hz
• Treble control offers +18 dB boost at 4 kHz
• Total harmonic distortion (THD): 0.18% at 1 kHz
• Input impedance: 1 Mohm
• Output impedance: 1 kohm
• Powered via a 9 V battery (not included)
• Power consumption: 9 mA
• Installation depth: 29 mm
• Dimensions of motherboard (L x W x D): 30 x 21 x 25 mm
• Up to 870 hours of battery life

Note: Register your instrument at www.w-distribution.de/Warranty to extend the warranty to 4 years.

• 3 Potentiometers for electric basses
• Tandem potentiometers with active 2-Band equaliser
• Treble and bass +/- 12 dB
• 4 Center frequencies (2100, 3500, 4500, 7000 Hz) switchable
• With additional balance potentiometer and master volume potentiometer
• Only for EMG pickups

• Active / Passive switch (push / pull on the volume control)
• Balance pot without volume reduction in centre position
• Treble pot: +/- 18 dB @ 18 kHz, in active mode
• Bass pot: +/- 14 dB@40 Hz, in active mode
• Battery voltage supply: 9 V / 18 V
• Due to the high-quality of the electronics, there is no audible difference between active and passive mode when pots are in centre position
• Delivered preassembled and already wired with highly flexible cables

• For electric basses
• Like the BQC system but with a 5-pot design
• Only for use with EMG pickups
• Balance control (blend) and master volume with separate bass and treble pots
• Concentric mid-control (stacked)
• Solderless

EMG EXB Bass Expander; unconventional Equalization control for Bass that increases the low and high frequency regions while reducing the Midrange; provides the Clear Gain and Percussive Punch that especially Slap Bass players will appreciate; incl. Output Jack and Battery Clip set, Note: only suitable for EMG pickups

• Provides the transparency of the Microtube B7K EQ as a built-in pre-amp
• Control: Bass + -12 dB @ 70Hz - Mids: + -12 dB @ 500Hz - Hi Mids + -12 dB 2.8kHz
• Including potentiometer
• The Tone Capsule can be used with one or two batteries in series for 9 V or 18 V operation (battery clips not included)

• 4 Potentiometer
• Active / passive switch (at volume control push / pull)
• Balance control without volume reduction in the center position
• Treble control in active mode +/- 18 dB @ 18 KHz
• Bass control +/- 14 dB @ 40 Hz
• Mid control +/- 9 dB @ 550 Hz
• Battery voltage: 9 V / 18 V
• Thanks to the high-quality electronics, there is no difference between active and passive operation when the tone controls are in the middle position
• Prewired with highly flexible cables
• The treble / bass control is stacked
• In passive mode, there is no tone control

• Bass, semi-parametric mids and highs over 2 concentric / stacked potentiometers
• Centering for neutral setting
• Adjustable mid-frequency range from 100 Hz to 1 kHz
• Including solderless cables, potentiometers, battery clamp & jack socket

• With 2-band EQ
• To connect to active or passive pickups
• 4 Knobs for volume, treble, bass and balance

• With everything you need for pickup installation of a PJ set configuration of active EMG solderless bass pickups
• Potis with corrugation axis (standard length)

Set Includes:

• 2x Volume pots
• 1x Tone poti
• 1x Pickup bus
• 1x Power bus
• 1x 12B output jack with battery clip
• 1x Output cable
• 4x Interconnect cables
• 2x Pickup cables

Note: Only for active Tonabhnehmer.

• 4 Controllers
• Suitable for Music Man electric bass

• 5 Potentiometers
• Balance control without volume cut in mid position
• Treble control in active mode +/- 18 dB@18 KHz
• Treble control in passive mode as classic treble control
• Bass control +/- 14 dB@40 Hz
• Mid control +/- 9 dB@550 Hz
• Battery voltage: 9 V / 18 V
• Due to the high quality electronics, no difference can be heard between active and passive operation when the tone controls are in mid position
• Supplied pre-wired with highly flexible cables

• The most versatile Aguilar bass preamp
• +/- 18 db for Bass (40 Hz)
• +/- 16 dB for thomann Mid (400 or 800 Hz)
• +/- 16 dB for Treble (6.5 KHz).
• Can be operated with one or two 9V batteries

Included in delivery:

• Preamp
• 3 Potentiometers for bass, mid and treble
• Mini-switches for the selection of the central frequency